Before & After Photos

The 10-mil vapor barrier used to cover the dirt floor is not installed properly. Cracks and openings can be seen at every pier, wall, and pipe. Moisture from the earth is still able to seep through these small openings and gaps and affect the relative humidity. The vapor barrier does not even cover the outside grade through the foundation walls. Outside moisture from the earth can seep through the porous walls.

The 10-mil vapor barrier was replaced with a heavy-duty CleanSpace liner, which was sealed around all piers and pipes, and mechanically fastened to the foundation wall six to eight inches above outside grade. With the spray foam on the walls, the CleanSpace helps to protect the crawl space from any moisture from the earth, and with an antimicrobial built into the 7-layer polyethylene liner, it is better protected from mold and mildew.

These homeowners in Virginia Beach wanted to replace their existing crawl space access well, which was full of dirt and rocks and was allowing outside air and moisture to leak into the crawl space where the well meets the crawl space door.

Our solution was to install The Turtl crawl space access system, designed for below-grade crawl space access. The Turtle provides a clean and convenient access to the crawl space while keeping debris like leaves and rocks out of the way. This durable and lockable access door is made from rigid plastic, which will not rot, rust, corrode, or require new paint and is weathertight.

This Williamsburg, VA attic has several dormers. As part of air-sealing and insulating the attic space, we needed to install PVs (the gray rectangles you see between the rafters) to ensure that no insulation fell into the soffits and so that proper ventilation can be maintained in the attic. Then we installed an R-38 of Cellulose Insulation. 

Moisture and high humidity in this crawl space resulted in mold and mildew growth and damage to the insulation. The homeowner wanted to encapsulate the space, so our team set to work cleaning out the crawl space, air sealing vents, the rim band, sill plate, and any other openings through the foundation wall to the outside. They treated the microbial growth with an antimicrobial, installed a new CleanSpace Vapor Barrier, applied Foam Board insulation to the foundation walls, and installed a dehumidifier to regulate the relative humidity. 

After sealing and insulating this crawl space, we need to make sure we control the relative humidity. This is achieved by installing a dehumidifier with a hygrometer. The dehumidifier will be set to cut to on when the humidity reaches about 55% our goal is to prevent it from getting high enough that microbial growth can occur in the crawl space. We don't want the space to be too dry either because that can be damaging to the home's structure as well. A hygrometer is provided to the homeowner that allows them to monitor the temperature and relative humidity in the crawl space from inside their home.