Before & After Photos

Initially, this crawl space was encapsulated with a 6-mil vapor barrier and R-11 vinyl faced fiberglass insulation. Thhomeownerer contacted us with concerns about an ammonia, or animal urine odor in her home and poor air sealing. 

Our goal was to remedy the Home Owner’s concerns of foul odors in her home and wasted energy. To achieve this, we installed a 20 mil Clean Space Vapor Barrier on the floor of the crawl space and around the piers. We installed Foamax board insulation on the walls leaving a 3-inch viewing strip for pest control companies to do their inspection. We applied spray foam insulation to the rim and band and sill plate to create an air seal and reduce drafts coming into the crawl space. Finally, we installed a Sani Dry Sedona Dehumidifier, the leading dehumidifier on the market, to pull any moisture that enters the crawl space out. 

This crawl space was originally encapsulated at construction with a 6 mil Vapor Barrier and R-11 vinyl faced fiberglass insulation. The homeowner complained of an animal urine or ammonia odor in their home. This was a result of moisture entering the crawl space through the porous cinder block walls and saturating the fiberglass insulation. 

We installed a 20 mil Clean Space Vapor Barrier, Foamax Insulation Board, sealed the rim & band and sill plate, and installed a SaniDry Sedona Dehumidifier. This approach will help keep moisture out of the crawl space and control relative humidity. 

We replaced the vapor barrier within this Midlothian crawl space. The problem with the existing vapor barrier was that it had many gaps and holes within it, allowing the earth's moisture to rise into the crawl space. The moisture that becomes trapped within the crawl space will raise the relative humidity levels, leading to condensation in certain temperatures, and even mold or mildew growth. We replaced this inadequate liner with our own CleanSpace Light vapor barrier. The CleanSpace Light is a 10mil liner that covers the entire dirt floor of the crawl space, gets wrapped around each pier, and is mechanically fastened to the foundation walls six to eight inches above outside grade. A two-inch viewing strip is left at the top of the foundation walls for termite inspectors. This high-quality vapor barrier will help to reduce the earth's moisture from affecting the relative humidity of the crawl space, and it gives a bright, clean aesthetic to the crawl space.

This crawl space had issues with mildew/mold, falling insulation, an ineffective vapor barrier, and moisture concerns in the home. We removed the old insulation and vapor barrier, treated the mildew/mold, installed a new vapor barrier, applied spray foam insulation on the crawl space walls, sealed all the vents, the rim and band, and sill plate, and insulated behind the crawl space door, then installed a dehumidifier to control relative humidity. 

We installed about 1.5 inches of closed-cell spray foam over the foundation walls of this crawl space in Glen Allen, VA. At this thickness, the spray foam has an R10 value of insulation and acts as an air barrier and vapor retarder. We blocked out any open vents running along the crawl space wall, as these vents allow outside air and moisture to freely enter to crawl space, affecting the environment and relative humidity. With any insulation we install over the foundation walls, we always leave a 2-inch viewing strip at the top of the wall for termite inspectors. With these solutions in place, the crawl space is better protected from any outside influence penetrating through the foundation walls.