Before & After Photos

Maurice knows the home he's living in is his forever home. That's why it's so important to him to maintain it. He started to get concerned when the door leading to the breezeway would not shut. So to get to the bottom of it, he called Thrasher. 

We sent Clint Gerber to inspect. Clint found that the concrete in their garage had settled in multiple areas. This is what was causing the door to not operate correctly and was creating tripping hazards. 

To resolve their problem, we utilized PolyLevel foam for lifting their concrete, and then we used NexusPro sealant to seal all cracks and joints. 

Maurice was thrilled with the outcome!

Melvin P. was concerned with the uneven concrete surrounding his mother’s home in New Cambria, KS. There was a new concrete slab that was poured near the back patio a few years ago, and it had begun to sink, creating an extreme tripping hazard. After meeting with our System Design Specialist Aj LaVoie, he put his trust in Thrasher to provide a quality permanent solution.

Our crews arrived at the home in New Cambria, KS, and immediately began installing our 2-part Concrete Protection System. They started by injecting our PolyLevel foam underneath the sunken slabs to lift and level the surface. Then, our NexusPro joint sealant was applied to all cracks and control joints to prevent any water damage in the future. Our crews thoroughly cleaned up the workspace and showed Melvin the results.

He couldn’t have been happier with the effectiveness of our concrete repair solution. Not only did we repair the concrete, but we restored Melvin’s peace of mind knowing his mother has a safe surface to walk on when she pleases.

Homeowner Mary P. of Newton, KS was worried about her concrete. She noticed certain areas were having significant settlement. After getting multiple recommendations about Thrasher and hearing about our process, she gave us a call to come out and inspect her concrete.

System Design Specialist Ben Linnebaur went out to Mary’s home. Upon inspection, he was able to see that the front steps had settled about 1.5 inches and her back A/C slab was also sinking. The crew fixed her concrete with a 3- part concrete protection system. The first part consisted of lifting the settled areas with PolyLevel. For the second part, we sealed all of the cracks and joints with NexusPro Joint Sealant. The third step consisted of applying the whole area with SealantPro, a protective layer to keep the area free of stains. Mary was impressed with the install and the crew!

This homeowner wanted to fix the concrete surrounding his pool. It was cracking pretty bad due to the settlement of the sand underneath. Brent See went out to the home to look at the concrete. Upon inspection, he found one section of the slab completely failed, and another was about to fail. Brent was convinced that the first section was too far gone and would have to be replaced. Our install crew member, Jason Nelson, was not only able to stabilize the concrete, but he was also able to raise several spots around the pool without damaging it. 

The homeowner was so happy we were able to fix his concrete and reduce those significant tripping hazards with no damage to the pool at all!

Hank K.’s upper driveway was starting to sink causing a big bump to form and he would have to drive his car over that each time to pull into the garage. Hank was tired of the bump and wanted  level and stabilize the concrete.

After hearing great things about Thrasher,  he decided to give us a call. We had System Design Specialist, Miles Hodson go out and he was able come up with a solution. We started with applying  PolyLevel to lift the concrete making the bump less noticeable. We then applied NexusPro Joint Sealant to seal the joints in the driveway and up to the front porch. Hank was not only impressed with the quality of work but how the production crew was efficient and cleaned up well.